Routabout
Hep2O®
Routabout Hole Cutter
This unique system solves the problem of underfloor access found by
all builders, plumbers and other trades. A 250mm diameter opening
can be cut and made good in minutes. Designed for use in new or existing
18mm & 22mm chipboard or similar floors, the Routabout cuts only the
thickness of the board, thus leaving no waste and the piece cut out
is used to make good the floor. The starter kit includes special tungsten
cutter, template and four spacer rings, additional rings are available
separately. A router (750 watts or above) and a 30mm guide bush will
be required.
The routabout starter pack contains: |
 |
1
x Routabout rotating template. |
|
1
x Special tungsten router cutter. |
|
1
x 25mm x No. 8 chipboard screw. |
|
| You
will also need: |
|
1
x 1/4 inch or 1/2 inch collet to fit a medium sized plunging
type router (not supplied). |
|
1
x 30mm (outside dia) guide bush - fitted to router (not supplied).
|
|
 |
| Figure
No. 28 |
|
Router
|
|
Tungsten
router cutter |
|
Routabout
rotating template |
|
Routabout
spacer ring |
|
 |
| Figure
No. 29 |
|
Routing
the flooring sheet using the Routabout rotating template.
|
|
 |
| Figure
No. 30 |
|
The
routabout spacer ring provides access in the floor sheet
to the pipework. |
|
 |
| Figure
No. 31 |
|
The
chipboard cutout fits snugly into the spacer ring, leaving
a neat access. |
|
|
