Conduit Systems

The Hep2O® Conduit system allows pipe and fittings to be installed directly into concrete floors or into walls whilst complying with the requirements of the Water Byelaws.

The flexible conduit allows Hep2O® to be withdrawn for inspection, and junction boxes allow maximum accessibility to fittings for inspection and possible removal.

To allow pipework to be easily replaced or terminated in the future only Demountable fittings should be used within the junction boxes. Spigot tees in 22 x 15mm and 15 x 10mm sizes are available to build up manifold configurations. If any bent sections of conduit pipe are formed in an installation then future replacement of the Hep2O® is likely to require the use of a 'draw cable'.

In this event the draw cable should be attached to one end of the Hep2O® before it is pulled out from the other end. Replacement of a new section of Hep2O® pipe may require two operatives; one pulling the draw cable which is attached to the pipe end and the other person feeding-in the new length from the opposite end. Future replacement will be easier if conduit bends are kept to a minimum and any radius kept as large as practicable.

The system consists of two sizes of flexible conduit, junction boxes with lids and terminal fittings.

Holes can be cut in the sides of the junction box at the appropriate position to accommodate the conduit which simply clicks into position. Hep2O® Conduit Pipe is available in the sizes shown in

Table No. 6. Conduit and Pipe in Pipe Lengths